Skip to main content

The Distributed Energy Canard

By Eric McErlain
One of the most common arguments anti-nukes use against nuclear energy concerns the fact that a nuclear power plant is a "centralized" source of energy that can be controlled by big, bad corporate interests. In contrast, the thinking goes, renewables like wind and solar support a model of "distributed" generation that would free consumers from evil corporate utilities.

Today over at Daily Kos, N. Nadir takes a shot at that contention.
Labels:

Comments

DV8 2XL said…
Retasking the electrical distribution system is a non-trivial problem and in many instances this critical issue is breezed over in discussions of distributed energy. This is a mistake. This system is huge and complex, with a bewildering number of control nodes and operates under protocols that been less designed then they have accumulated. It has not been built for two-way traffic, and even in cases where bi-directional flow is physically possible it is often achieved only by overriding system fail-safes, and potentially compromising product integrity. Refitting to allow for this, while certainly doable from the engineering standpoint, would be horrendously expensive, and in some cases would require that large chunks of the network go offline or isolate for extended periods of time and in most cases this factor alone makes conversion unfeasible.

Integrating small generators into the grid like an energy internet also requires each node, whether a gigawatt natural gas power station or a single solar photovoltaic panel has to be controlled and the necessary number of combined control tasks multiply as devices multiply. Accurate information on the state of the network and coordination between local control centers and the generators is essential. However an inherent risk of interconnected networks is a domino effect - that is a system failure in one part of the network can quickly spread. Therefore the active network needs appropriate design standards, fast acting protection mechanisms and also automatic reconfiguration equipment to address potentially higher fault levels. On top of which most of the proposed systems require intelligent loads as well, adding to network complexity and cost. These changes are not cheap or easy.
March 15, 2007 at 7:24 AM
Post a Comment

Popular posts from this blog

Activists' Claims Distort Facts about Advanced Reactor Design

By
Below is from our rapid response team . Yesterday, regional anti-nuclear organizations asked federal nuclear energy regulators to launch an investigation into what it claims are “newly identified flaws” in Westinghouse’s advanced reactor design, the AP1000. During a teleconference releasing a report on the subject, participants urged the Nuclear Regulatory Commission to suspend license reviews of proposed AP1000 reactors. In its news release, even the groups making these allegations provide conflicting information on its findings. In one instance, the groups cite “dozens of corrosion holes” at reactor vessels and in another says that eight holes have been documented. In all cases, there is another containment mechanism that would provide a barrier to radiation release. Below, we examine why these claims are unwarranted and why the AP1000 design certification process should continue as designated by the NRC. Myth: In the AP1000 reactor design, the gap between the shield bu...
23 comments
Read more

What Happens During a Refueling Outage?

By
You may have noticed over the past few weeks that a number of nuclear plants are shut down for refueling outages or are resuming operations after just returning from one. This type of routine outage usually occurs in the spring or fall when electricity demand is low so that nuclear reactors can replace about one-third of the spent fuel rods with new fuel and conduct other routine maintenance and repairs at the plant. To get a better sense of how refueling works at a nuclear energy facility, I spoke with Marcus Nichol, NEI’s senior project manager for used fuel storage and transportation, and asked him to explain the basics. Why does a nuclear plant need to replace one-third of its fuel? Nichol: The main purpose of a refueling outage is to replace older fuel that is depleted—meaning it can no longer efficiently produce energy from nuclear fission reactions—with new fuel. This “used fuel” has typically been used in the reactor for four-and-a-half to six years before it is pe...
6 comments
Read more

Nuclear Utility Moves Up in Credit Ratings, Bank is "Comfortable with Nuclear Strategy"

By
Some positive signs that nuclear utilities can continue to receive positive ratings even while they finance new nuclear plants for the first time in decades: Wells Fargo upgrades SCANA to Outperform from Market Perform Wells analyst says, "YTD, SCG shares have underperformed the Regulated Electrics (total return +2% vs. +9%). Shares trade at 11.3X our 10E EPS, a modest discount to the peer group median of 11.8X. We view the valuation as attractive given a comparatively constructive regulatory environment and potential for above-average long-term EPS growth prospects ... Comfortable with Nuclear Strategy. SCG plans to participate in the development of two regulated nuclear units at a cost of $6.3B, raising legitimate concerns regarding financing and construction. We have carefully considered the risks and are comfortable with SCG’s strategy based on a highly constructive political & regulatory environment, manageable financing needs stretched out over 10 years, strong partners...
Post a Comment
Read more