Skip to main content

Wind a Boon(e?) for Gas

The Wall Street Journal's Environmental Capital blog today points to a WSJ op-ed by European writer Edgar Gärtner on the link between wind and gas. He cites European experience showing that increasing deployment of wind turbines in Spain and Germany coincides with greater dependence on gas, needed to support wind generation that can drop off at any time. He suggests that this may be why gas producers are eagerly promoting wind development - it is an effective way to promote demand for natural gas and the value of natural gas holdings. Gärtner concludes:
Wind power is clearly not reducing the dependence on imported fuel, contrary to the frequent claims of its proponents. In fact the experience from Germany and Spain shows that it is increasing the dependence of imported natural gas. And that's not energy security.

Comments

Anonymous said…
Anyone with any knowledge of how electricity supply is managed will know this is true. Wind capacity has essentially zero dispatchability. It is a chaotic, intermittent energy source. You're going to need quick-start backup capacity to fill the (many) gaps that occur when the wind isn't blowing at optimal speed, and right now that means NG-fueled generation. Those who advocate large-scale deployment of wind-based capacity are really advocating increased use of natural gas as a source of electricity, and that is a recipe for disaster.
Arvid said…
One one hand you will need natural gas (or hydro...) CAPACITY to deal with intermittency, but the total amount of gas consumed is bound to go down compared to when not having wind power.
Joffan said…
Let's take the easy case, arvid, where there's no hydro capacity. Then every time we build more wind power, we commit to having rapid-response power, which will be gas, to back it up. That's gas that's entrenched in the system - we can't get rid of it without also getting rid of the wind turbines. So although we don't burn gas when the wind blows, we're committing to burn it the other 75% of the time.

For most countries, hydro is limited. Once we have installed wind that matches the reservoir hydro capacity, additional wind will find itself entrenching gas usage in the same way.

For countries that have new gas generation plant, I'd say that using some wind to reduce gas usage during the phase-out will be good - that infrastructure needs to show some return. But after that, 20, 30 years? It would need a miracle of CO2 reclamation technology to make it worthwhile to keep the gas+wind system.
Anonymous said…
Arvid,

It is not at all clear that gas use will go down, for the reasons Joffan gives.

A significant amount of highly variable wind generation capacity all but requires a similar amount of gas (not coal or nuclear) capacity to be present. Given that the gas plants will be operating ~2/3 of the time, it means that the annual gas generation (kW-hrs) will have to be almost twice the annual wind generation. Thus, for wind to provide 20%, gas would have to be almost 40%, i.e., twice the fraction we have today.

We had a discussion about this over at EnergyPulse, in the comment section for a given article. Check it out at:

http://www.energypulse.net/centers/article/article_display.cfm?a_id=1790

Jim Hopf
Arvid said…
No matter what you'll need either gas or hydro to take care of your demand peaks.

Why not add wind to the system? When the wind is blowing that'll reduce the need for gas or hydro and when it's not you burn as much gas as you usually do.

The key to understanding the usefullness of wind is to see it as an intermittent gas saver in gas plants and as a way of saving water in the dams for later more profitable use.
Rod Adams said…
It is a logical fallacy to assume that it is not possible to provide rapidly varying power with sources other than gas. Both coal and uranium have long and proven histories of use in systems that respond rapidly to changes in power demand.

Coal's history in rapid response systems like ship propulsion units, however, is a bit ancient and requires either conveyors that can be speeded up or slowed down along with smaller units than are typically built. Of course, we could go all the way back to the days of stokers, but I think they would be hard to find these days.

For nuclear fission, however, there are a number of very responsive units in operation today on aircraft carriers, submarines and ice breakers. Fission reactors can change the heat they produce very rapidly and if they are connected to an appropriately designed steam plant or gas turbine, the power output from those units can also be varied rapidly.

On the flip side, I see no real reason, outside of the fact that some people seem to like enormous structures of often useless machinery, to integrate wind in with a future zero emission nuclear dominated grid, but that is a separate issue.
Joffan said…
Arvid, demand peaks are indeed a tricky supply problem; but the logical outcome of using wind to meet some of this requirement is that the wind is NOT USED AT ALL outside of those peaks. This will lead to horrendously low capacity usage of wind generation equipment. Only when hydro and gas are meeting more than just peaks can wind really be used to substitute energy for these systems.

The systemic alternative to having additional responsive generation capacity for your demand peaks is to have an element of very responsive demand instead (which will of course be charged less for the highly intermittent electricity). This could allow us to chop the rapid demand changes down to something that can be handled more efficiently with load-followers. Enough of this, and wind could be used again - but would command a much reduced price.

Popular posts from this blog

Activists' Claims Distort Facts about Advanced Reactor Design

Below is from our rapid response team . Yesterday, regional anti-nuclear organizations asked federal nuclear energy regulators to launch an investigation into what it claims are “newly identified flaws” in Westinghouse’s advanced reactor design, the AP1000. During a teleconference releasing a report on the subject, participants urged the Nuclear Regulatory Commission to suspend license reviews of proposed AP1000 reactors. In its news release, even the groups making these allegations provide conflicting information on its findings. In one instance, the groups cite “dozens of corrosion holes” at reactor vessels and in another says that eight holes have been documented. In all cases, there is another containment mechanism that would provide a barrier to radiation release. Below, we examine why these claims are unwarranted and why the AP1000 design certification process should continue as designated by the NRC. Myth: In the AP1000 reactor design, the gap between the shield bu...

How many nuclear plants does it take to meet the world's energy needs?

Several weeks ago Joshua Pearce at Clarion University in Pennsylvania released a study titled “ Thermodynamic limitations to nuclear energy deployment as a greenhouse gas mitigation technology .” In the study he stated... nuclear energy production would have to increase by 10.5% per year from 2010 to 2050 to both replace fossil-fuel-energy use and meet the future energy demands. This line, of course, made the headlines and has been picked up by several outlets and blogs . When looking into his calculations for this statement, he made one assumption error that overstated the above sentence by nearly a factor of three. Page 121, Section 4.1 of the study states: Richard Smalley pointed out that in 2004, the global economy consumed the equivalent of 220 million barrels of oil per day, which converted into electricity terms is the equivalent of 14.5 TeraWatts (TW), or 14,500,000 MegaWatts (MW) (2005). … With a nuclear plant having about 1000 MW (1 GW) of capacity, we would need 14,500...

What Happens During a Refueling Outage?

You may have noticed over the past few weeks that a number of nuclear plants are shut down for refueling outages or are resuming operations after just returning from one. This type of routine outage usually occurs in the spring or fall when electricity demand is low so that nuclear reactors can replace about one-third of the spent fuel rods with new fuel and conduct other routine maintenance and repairs at the plant. To get a better sense of how refueling works at a nuclear energy facility, I spoke with Marcus Nichol, NEI’s senior project manager for used fuel storage and transportation, and asked him to explain the basics. Why does a nuclear plant need to replace one-third of its fuel? Nichol: The main purpose of a refueling outage is to replace older fuel that is depleted—meaning it can no longer efficiently produce energy from nuclear fission reactions—with new fuel. This “used fuel” has typically been used in the reactor for four-and-a-half to six years before it is pe...