Skip to main content

Morning Report

From NEI’s Japan Earthquake launch page:

UPDATE AS OF 11:00 A.M. EDT, MARCH 23:

Workers continued efforts on Wednesday to restore offsite power to six reactors at the Fukushima Daiichi nuclear power plant. External power was available Wednesday at reactors 2, 3, 5 and 6, the Japan Atomic Industrial Forum said, but has not yet been re-established to reactor safety systems.

The next step before fully connecting external power is to test and repair the equipment that it will power. Cooling pumps for reactors 1 and 2 were covered by seawater and will require maintenance to bring them online. Tokyo Electric Power Co. is testing the cooling water pumps for reactor 3. External power was connected to the main control room at reactor 3 on Tuesday.

Reactors 5 and 6, which were shut down for maintenance at the time of the earthquake, are in safe shutdown.

"The earthquake and tsunami may have inflicted considerable damage in addition to knocking out electricity supplies," the International Atomic Energy Agency said. "Since the extent of this damage (and therefore the extent of necessary repair) is unknown, it is not possible to accurately estimate a work schedule."

Japanese authorities have detected high levels of radioactive cesium 137 in soil about 40 kilometers northwest of the Fukushima plant. Surveys of radioactive substances in soil at six locations found levels of cesium 137 that are 1,600 times typical for that area. Japan's government is expanding offshore monitoring for radioactive nuclides to 30 kilometers.

Japanese authorities have advised Tokyo residents not to provide municipal drinking water to infants or use it in mixing powdered milk for infants because of abnormal levels of radioactive iodine (I-131) detected in the drinking water. One water sample (5,700 picocuries per liter) indicated approximately twice the Japanese government guideline and prompted the restriction for infants. In an emergency in the United States, state and local officials would closely monitor food and drinking water supplies and quarantine any contaminated supplies as needed to prevent public exposure. U.S. officials use pre-established guidelines for safe consumption of food and water set by the U.S. Food and Drug Administration.

The U.S. Department of Energy has released the first radiation data from its aerial monitoring system and ground detectors in Japan. The department will update the data regularly. For the latest information, click here.

Comments

Unknown said…
I went to the DOE site linked in the last paragraph and downloaded the slides showing the data from the aerial monitoring. Slide 4 shows the monitoring results from 3 survey dates giving results in mR/hr. Slide 5 shows cumulative aerial monitoring results. But these results were also in mR/hr.

Can you please explain how cumulative results can be shown using units of mR/hr?

Popular posts from this blog

Activists' Claims Distort Facts about Advanced Reactor Design

Below is from our rapid response team . Yesterday, regional anti-nuclear organizations asked federal nuclear energy regulators to launch an investigation into what it claims are “newly identified flaws” in Westinghouse’s advanced reactor design, the AP1000. During a teleconference releasing a report on the subject, participants urged the Nuclear Regulatory Commission to suspend license reviews of proposed AP1000 reactors. In its news release, even the groups making these allegations provide conflicting information on its findings. In one instance, the groups cite “dozens of corrosion holes” at reactor vessels and in another says that eight holes have been documented. In all cases, there is another containment mechanism that would provide a barrier to radiation release. Below, we examine why these claims are unwarranted and why the AP1000 design certification process should continue as designated by the NRC. Myth: In the AP1000 reactor design, the gap between the shield bu...

What Happens During a Refueling Outage?

You may have noticed over the past few weeks that a number of nuclear plants are shut down for refueling outages or are resuming operations after just returning from one. This type of routine outage usually occurs in the spring or fall when electricity demand is low so that nuclear reactors can replace about one-third of the spent fuel rods with new fuel and conduct other routine maintenance and repairs at the plant. To get a better sense of how refueling works at a nuclear energy facility, I spoke with Marcus Nichol, NEI’s senior project manager for used fuel storage and transportation, and asked him to explain the basics. Why does a nuclear plant need to replace one-third of its fuel? Nichol: The main purpose of a refueling outage is to replace older fuel that is depleted—meaning it can no longer efficiently produce energy from nuclear fission reactions—with new fuel. This “used fuel” has typically been used in the reactor for four-and-a-half to six years before it is pe...

How Much Land Does Nuclear, Wind and Solar Really Need?

Not too long ago, we reviewed a report that looked at nuclear energy (and other energy sources) as biodiversity agents. This had to do, in part, with the amount of land a facility needs to function. Nuclear energy and fossil fuel plants use relatively little, wind farms and solar arrays quite a lot of land . Based on an objective and transparent analysis of our sustainable energy choices, we have come to the evidence-based conclusion that nuclear energy is a good option for biodiversity conservation (and society in general) and that other alternatives to fossil fuels should be subjected to the same cost–benefit analyses (in terms of biodiversity and climate outcomes, as well as sociopolitical imperatives) before accepting or dismissing them. Writer Barry Brook, who collected 75 scientists to endorse his paper, is interested in land use as it impacts flora and fauna. Biodiversity concerns do not get as much play as they might – and, when they do, it annoys many when land is withdraw...